Skip to content

Technology

Compression technology

The compression cycle explained, and how a gas engine-driven compression heat pump works.

Electric heat pumps

Electric heat pumps use the same vapour compression cycle, but the compressor is driven by an electric motor.

The cycle transfers thermal energy from a lower-temperature source to a higher-temperature user circuit, using electricity as the driving energy.

System performance depends on several factors, including:

  • Heat source temperature.
  • Required flow temperature.
  • Temperature difference between evaporation and condensation.
  • Compressor technology.
  • Refrigerant used.
  • Operating conditions and load profile.

Advances in refrigerants make it possible to build units with a low global warming potential (GWP) and, in certain configurations, to use natural refrigerants such as R290 (propane) and R744 (CO2), as well as very low-GWP HFO refrigerants such as R1234ze(E) and R1233zd(E).

Each refrigerant has different thermodynamic properties, working pressures, critical temperatures and safety requirements. Choosing the refrigerant is therefore part of the cycle design and determines how the cycle can operate.

Air-to-water heat pumps

In an air-to-water heat pump, the air acts as the heat source or heat sink and the hydraulic circuit delivers the useful thermal energy to the installation.

In heating mode, the evaporator extracts thermal energy from the air and the condenser transfers the heat to the water circuit.

In simplified form:

Air → Evaporator → Compressor → Condenser → Hot water

Air-to-water compression heat pump

How the cycle performs depends on the source conditions and the required water temperature. The greater the temperature lift, the more work the compressor normally has to do and the lower the instantaneous efficiency of the cycle.

Natural refrigerants such as R290 or R744, and other low-GWP refrigerants, allow these technologies to be adapted to different temperature ranges and operating conditions.

Water-to-water heat pumps

Water-to-water heat pumps exchange energy between two hydraulic circuits through a compression refrigeration cycle.

One circuit acts as the heat source and the other as the user circuit.

The source can be, among others:

  • Waste heat from industrial processes.
  • Cooling circuits.
  • Return water.
  • Geothermal sources.
  • Condensing circuits.
  • Other available heat sources.

One of the main advantages of this configuration is that it can work with a heat source whose temperature and stability may be more favourable than those of outdoor air.

The cycle recovers waste heat and raises its temperature level, turning energy that cannot be used directly into useful heat for a process or installation.

In simplified form:

Heat source → Evaporator → Compressor → Condenser → User circuit

Water-to-water compression heat pump

High-temperature industrial heat pumps

High-temperature industrial heat pumps use the vapour compression cycle to recover thermal energy available at low or medium temperature and raise it to levels suitable for industrial processes.

The principle is especially attractive where waste heat is currently released to the environment or removed by cooling systems.

The process can be shown in simplified form:

Waste heat → Evaporator → Compressor → Condenser → Useful high-temperature heat

Industrial heat recovery with a high-temperature heat pump

The maximum achievable temperature depends on the system architecture, the compressor, the refrigerant, the source conditions and the required condensing temperature.

Current technologies make it possible to build industrial heat pumps for different temperature ranges, including high-temperature applications and process heat recovery.

Low-GWP refrigerants, including certain HFOs and natural refrigerants, allow the cycle to be adapted to different temperature levels and environmental requirements.

Manufacturers

Manufacturers

Which technology suits your installation?

We'll help you compare absorption, compression and cogeneration based on the energy available and the demand.

Be the first to know

Sign up for the latest news, exclusives and offers from Absorsistem

To download the document, please enter your email address.

Thank you! Your download has started.

Something went wrong. Please try again later.

Please check the highlighted fields.